Sending Coins - RUPX and zRUPX

These instructions are intended for those that want instructions on how to send RUPX and zRUPX. This process is useful for those that want to convert your zRUPX back into RUPX and for consolidating coins into a single wallet input for better staking results.

Sending RUPX

  1. Locate and copy the Rupaya wallet address that you are sending coins to.

  2. Open the Rupaya wallet(s) that currently contains RUPX.

  3. From the side wallet bar, click Send.

  4. In the Pay To: field, right click and select Paste to paste in the wallet address that you copied in Step 1.

  5. Click Open Coin Control.

    If you haven’t already enabled Coin Control then follow these steps:

    • From the Rupaya Wallet, click on Settings, select Options, click on the Wallet tab and then click the check-box that says Enable coin control features.
    • This feature will allow you to control your wallet inputs, to verify that all coins are consolidated into a single input, to choose which inputs you send coins from, and to optimize staking.
  6. Click (un)Select all and ensure that all of the checkboxes are checked and that none of them are locked.

  7. Click OK to close the Coin Selection window.

  8. Locate the numbers next to the field After Fee and right click them and then select Copy after fee. This will copy the total amount of coins you have available to send after the fee is calculated.

  9. Right click in the Amount field box and select Paste. This will paste in the total amount of coins that you have available to send.

  10. Verify that the following information is correct:

    • Pay to wallet address is the correct wallet address you are consolidating all of the coins into.
    • Amount field is the correct amount of all of the coins in the wallet, after the fee is removed.
  11. Click Send to complete the transaction.

    • Enter your wallet passphrase, if prompted.
    • Click Yes when prompted to confirm that you are sure you want to send.

Sending zRUPX

  1. Locate and copy the Rupaya wallet address that you are sending coins to.

  2. Open your current Rupaya wallet(s) that currently contains zRUPX.

  3. From the side wallet bar, click Privacy.

  4. In the Pay To: field, right click and select Paste to paste in the wallet address that you will be sending zRUPX coins into.

  5. Click zRUPX Control.

    If you haven’t already enabled Coin Control then follow these steps:

    • From the Rupaya Wallet, click on Settings, select Options, click on the Wallet tab and then click the check-box that says Enable coin control features.
    • This feature will allow you to control your wallet inputs, to verify that all coins are consolidated into a single input, to choose which inputs you send coins from, and to optimize staking.
  6. Click Select/Deselect all until the checkboxes are NOT checked and then only check boxes next to 7 or less of the available inputs.

    • NOTE: If you select too many inputs then when you attempt to send the coins you will receive an error and the coins will not be sent.
  7. Click OK to close the Coin Selection window.

  8. Locate the numbers next to the field zRUPX Selected: and type that amount into the Amount: field at the bottom of the wallet.

  9. Verify that the following information is correct:

    • Pay to wallet address is the correct wallet address you are consolidating all of the coins into.
    • Amount field is the correct amount of all of the coins in the zRUPX Selected field.
  10. Click Spend Zerocoin to complete the transaction.

    • Enter your wallet passphrase, if prompted.
    • Click Yes when prompted to confirm that you are sure you want to send.
    • NOTE: If you receive the error: Failed to find coin set amonst held coins with less than maxNumber of Spends then you will need to disable zRUPX Automint and wait for the existing zRUPX to complete 200 block confirmations before you will be able to complete this step.